PCA9670PW 产品信息|NXP

PCA9670PW

正常供应

PCA9670PW

正常供应

购买选项

工作特点

参数
No of bits
8
VDD [min]
2.3
VDD [max]
5.5
Over volt tolerant
Y
No of supplies
1
Standby current [typ] (µA)
2.5
Max Sink Current per bit (mA)
25
Max Sink Current, per package (mA)
200
参数
Source Current per bit (mA)
0.1
Reset input pin
Y
Output mode
Quasi
Internal pull-up resistor per bit (kOhm)
Int I source
I2C-bus (kHz)
1000
Footprint body and leads
33.66
Operating Temperature (°C)
-40~85
No of Addresses
64

环境

部件/12NC无铅欧盟 RoHS无卤素RHF指标REACH SVHC重量(mg)
PCA9670PW,118(935282716118)
Yes
Yes
Certificate Of Analysis (CoA)
Yes
DREACH SVHC
52.41

质量

部件/12NC安全保障功能安全湿度灵敏度等级(MSL)封装体峰值温度(PPT)(C°)适合MTBFIR
铅焊接无铅焊接铅焊接无铅焊接
PCA9670PW,118
(935282716118)
No
1
1
240
260
2.0
5.0E8
0.0

配送

部件/12NC协调关税 (美国)免责声明
PCA9670PW,118
(935282716118)
854239

更多信息 PCA9670PW

The PCA9670 provides general-purpose remote I/O expansion via the two-wire bidirectional I²C‑bus (serial clock (SCL), serial data (SDA)).

The devices consist of eight quasi-bidirectional ports, 1 MHz 30 mA drive I²C‑bus interface, three hardware address inputs and a reset input operating between 2.3 V and 5.5 V. 1 MHz I²C‑bus Fast‑mode Plus (Fm+) can support PWM dimming of LEDs, and higher I²C‑bus drive 30 mA allows more devices to be on the bus without the need for bus buffers. The quasi-bidirectional port can be independently assigned as an input to monitor interrupt status or keypads, or as an output to activate indicator devices such as LEDs. The system controller can read from the input port or write to the output port through a single register

The low current consumption of 2.5 μA (typical, static) is great for mobile applications and the latched output ports have 25 mA high current sink drive capability for directly driving LEDs.

The PCA9670 has three hardware address pins and allows up to 64 of these PCA9670 I/O expanders on the same I²C‑bus without the need for bus buffers, supporting up to 512 I/Os (for example, 512 LEDs).

The internal Power-On Reset (POR) and active LOW hardware reset pin (RESET) initialize the I/Os as inputs with a weak internal pull-up 100 μA current source.

更多