Features
Battery Cell Controller, Advanced, 6 Channels, TPL, LQFP48.
Package
HLQFP48 LQFP64, plastic, low profile quad flat package; 64 terminals; 0.5 mm pitch; 10 mm x 10 mm x 1.4 mm body.
封装
HWQFN24: plastic thermal enhanced very very thin quad flat package; no leads; 24 terminals; 0.5 mm pitch, 4 mm x 4 mm x 0.75 mm body
购买选项
PCA9555AHF,128
正常供应
12NC: 935298087128
详细信息
数量
单价
| 1 - 24 | $0.92 |
| 25 - 99 | $0.92 |
| 100+ | $0.92 |
订购
现货:10,965
从分销商处购买PCA9555AHF,118
停产
12NC: 935298087118
详细信息
订购
工作特点
| 参数 | 值 |
|---|---|
No of bits | 16 |
VDD [min] | 1.65 |
VDD [max] | 5.5 |
Over volt tolerant | Y |
No of supplies | 1 |
Standby current [typ] (µA) | 0.5 |
Max Sink Current per bit (mA) | 25 |
Max Sink Current, per package (mA) | 200 |
Source Current per bit (mA) | 10 |
| 参数 | 值 |
|---|---|
Interrupt output pin | Y |
Output mode | Totem pole |
Input mode: invert option | Y |
Internal pull-up resistor per bit (kOhm) | 100 |
I2C-bus (kHz) | 400 |
Footprint body and leads | 16.81 |
Operating Temperature (°C) | -40~85 |
No of Addresses | 8 |
环境
| 部件/12NC | 无铅 | 欧盟 RoHS | 无卤素 | RHF指标 | REACH SVHC | 重量（mg） |
|---|---|---|---|---|---|---|
PCA9555AHF,118(935298087118) | No | No | - | REACH SVHC | - | |
PCA9555AHF,128(935298087128) | Yes | Yes Certificate Of Analysis (CoA) | Yes |  | REACH SVHC | 35.56007 |
质量
| 部件/12NC | 安全保障功能安全 | 湿度灵敏度等级(MSL) | 封装体峰值温度（PPT）（C°） | 适合 | MTBF | IR | ||
|---|---|---|---|---|---|---|---|---|
| 铅焊接 | 无铅焊接 | 铅焊接 | 无铅焊接 | |||||
PCA9555AHF,118 (935298087118) | - | - | - | - | - | 4.0 | 2.5E8 | 0.0 |
PCA9555AHF,128 (935298087128) | No | 1 | 1 | 240 | 260 | 4.0 | 2.5E8 | 0.0 |
配送
| 部件/12NC | 协调关税 (美国)免责声明 |
|---|---|
PCA9555AHF,118 (935298087118) | 854239 |
PCA9555AHF,128 (935298087128) | 854239 |
产品变更通知
| 部件/12NC | 发行日期 | 生效日期 | 产品更改通知 | 标题 |
|---|---|---|---|---|
PCA9555AHF,128 (935298087128) | 2017-11-08 | 2017-11-09 | 201710002I | Data Sheet Update for PCA9534 PCA9535 PCA9536 PCA9537 PCA9538PCA9539 PCA9554 and PCA9555 Devices |
更多信息 PCA9555A
The PCA9555A is a low-voltage 16-bit General Purpose Input/Output (GPIO) expander with interrupt and weak pull-up resistors for I²C-bus/SMBus applications. NXP I/O expanders provide a simple solution when additional I/Os are needed while keeping interconnections to a minimum, for example, in ACPI power switches, sensors, push buttons, LEDs, fan control, etc.
In addition to providing a flexible set of GPIOs, the wide VDD range of 1.65 V to 5.5 V allows the PCA9555A to interface with next-generation microprocessors and microcontrollers where supply levels are dropping down to conserve power.
The PCA9555A contains the PCA9555 register set of four pairs of 8-bit Configuration, Input, Output, and Polarity Inversion registers.
The PCA9555A is a pin-to-pin replacement to the PCA9555 and other industry-standard devices. A more fully featured device, the PCAL9555A, is available with Agile I/O features. See the respective data sheet for more details.
The PCA9555A open-drain interrupt (INT) output is activated when any input state differs from its corresponding Input Port register state and is used to indicate to the system controller that an input state has changed.
INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via the I²C-bus. Thus, the PCA9555A can remain a simple target device.
The device outputs have 25 mA sink capabilities for directly driving LEDs while consuming low device current.
The power-on reset sets the registers to their default values and initializes the device state machine.
All input/output pins have weak pull-up resistors connected to them to eliminate external components.
Three hardware pins (A0, A1, A2) select the fixed I²C-bus address and allow up to eight devices to share the same I²C-bus/SMBus.