Features
Battery Cell Controller, Advanced, 6 Channels, TPL, LQFP48.
Package
HLQFP48 LQFP64, plastic, low profile quad flat package; 64 terminals; 0.5 mm pitch; 10 mm x 10 mm x 1.4 mm body.
Battery Cell Controller, Advanced, 6 Channels, TPL, LQFP48.
HLQFP48 LQFP64, plastic, low profile quad flat package; 64 terminals; 0.5 mm pitch; 10 mm x 10 mm x 1.4 mm body.
TSSOP24: plastic, thin shrink small outline package; 24 leads; 0.65 mm pitch; 7.8 mm x 4.4 mm x 1.1 mm body
12NC: 935272394118
详细信息
12NC: 935272394112
详细信息
12NC: 935276421118
详细信息
参数 | 值 |
---|---|
Number of Channels | 16 |
Output Current on pin LEDn (Max) (mA) | 25 |
Supply Voltage [Min to Max] (V) | 2.3 to 5.5 |
Serial Communication | 1 x I²C |
Topology | Voltage switch |
参数 | 值 |
---|---|
Blinking Rate (Min to Max) (Hz) | 0.17 to 44 |
# of Addresses | 8 |
Operating Temperature (Min-Max) (℃) | -40 to 85 |
AEC-Q100 compliant | N |
部件/12NC | 无铅 | 欧盟 RoHS | 无卤素 | RHF指标 | REACH SVHC |
---|---|---|---|---|---|
PCA9552PW,112(935272394112) | Yes | Yes | Yes | REACH SVHC | |
PCA9552PW,118(935272394118) | Yes | Yes Certificate Of Analysis (CoA) | Yes | REACH SVHC | |
PCA9552PW/G,118(935276421118) | No | No | - | REACH SVHC |
部件/12NC | 安全保障功能安全 | 湿度灵敏度等级(MSL) | 封装体峰值温度(PPT)(C°) | 适合 | MTBF | IR | ||
---|---|---|---|---|---|---|---|---|
铅焊接 | 无铅焊接 | 铅焊接 | 无铅焊接 | |||||
PCA9552PW,112 (935272394112) | No | 1 | 1 | 240 | 260 | 2.0 | 5.0E8 | 0.0 |
PCA9552PW,118 (935272394118) | No | 1 | 1 | 240 | 260 | 2.0 | 5.0E8 | 0.0 |
PCA9552PW/G,118 (935276421118) | - | - | - | - | - | 2.0 | 5.0E8 | 0.0 |
部件/12NC | 协调关税 (美国)免责声明 |
---|---|
PCA9552PW,112 (935272394112) | 854239 |
PCA9552PW,118 (935272394118) | 854239 |
PCA9552PW/G,118 (935276421118) | 854239 |
部件/12NC | 停产通知 | 上次购买日期 | 上次发货日期 | 替代器件 |
---|---|---|---|---|
PCA9552PW,112 (935272394112) | NOTICE | 2018-08-31 | 2018-11-30 | PCA9552PW,118 (935272394118) |
PCA9552PW/G,118 (935276421118) | - | - | - | PCA9552PW,118 (935272394118) |
部件/12NC | 发行日期 | 生效日期 | 产品更改通知 | 标题 |
---|---|---|---|---|
PCA9552PW,112 (935272394112) | 2018-12-19 | 2018-12-20 | 201711018DNU02 | Product Discontinuation Notice - Align SOIC EOL Dates |
The PCA9552 LED blinker blinks LEDs in I²C-bus and SMBus applications where it is necessary to limit bus traffic or free up the I²C-bus controller's (MCU, MPU, DSP, chipset, etc.) timer. The uniqueness of this device is the internal oscillator with two programmable blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the bus controller must send repeated commands to turn the LED on and off. This greatly increases the amount of traffic on the I²C-bus and uses up one of the controller's timers. The PCA9552 LED blinker instead requires only the initial setup command to program BLINK RATE 1 and BLINK RATE 2 (that is, the frequency and duty cycle) for each individual output. From then on, only one command from the bus controller is required to turn each individual open-drain output on, off, or to cycle at BLINK RATE 1 or BLINK RATE 2. Maximum output sinks current is 25 mA per bit and 200 mA per package.
Any bits not used for controlling the LEDs can be used for General Purpose Parallel Input/Output (GPIO) expansion.
The active LOW hardware reset pin (RESET) and Power-On Reset (POR) initializes the registers to their default state, all zeroes, causing the bits to be set HIGH (LED off).
Three hardware address pins on the PCA9552 allow eight devices to operate on the same bus.